To Configure Quick Shifter

The Quick Shifter accessory for the Power Commander V, when enabled and set-up, will kill engine power for a moment when the shift lever is actuated, allowing full throttle shifts without the clutch.

1	Select Power Commander Tools Configure Quick Shifter.

2	Select the Enabled box.

3	Using the drop-down arrow, select a Mode.

Single Time—uses the same shift kill time for all shifts.

Gear Dependent—allows a different shift kill time for each gear change. Gear Dependent requires a gear indicator set-up. For more information, refer to To Calibrate the Gear Position.

4	Enter a Minimum RPM.

Below the Minimum RPM, the Quick Shift will not function.

5	Enter a Shift Interval.

The Shift Interval is the minimum time between each shift. If a second shift event occurs sooner than the length of time set here, it will be ignored.

6	Enter the Shift Kill times.

The Shift Kill Time is the amount of time (in milliseconds, 1000mS=1 second) that engine power will be cut for one shift event. If you selected Gear Dependent mode, set a shift kill time for each gear change.

7	Click OK to accept the changes.

Or

Click Cancel to close the window without changes.